Dental Lab Equipment

Specification

Packing size: 23*28*34cm

Weight: 6KG

Power supply: 1000W

Comes with a copy of the original laminated steel ball

USE

Braces forming, forming and making of bleaching braces

Appliance molding, orthodontic retainer, dental arch splint molding and fabrication

Tray forming, forming and fabrication of fluoride trays

Base forming, forming and production of temporary, permanent base and mouthguard

THE PURPOSE AND USE OF STEEL BALLS

Remove the aluminum box, place the model in the middle, then use steel balls to bury the part that does not need to be formed, and then put it on the machine table.

PRODUCT OPERATION

Rotate the upper cover (both left and right) 90°, put the required diaphragm

between the upper and lower casings, and pull down the ball head lever to clamp it.

Reset the upper cover, press the lifting wrench to raise the sleeve frame to the

working height, (the upper part of the main shaft is limited by the marble), and at

the same time place the packaged product in the center of the screen plate, turn on

the heating switch, heat the diaphragm, when the wax When the sheet is heated

below the lower frame plane 1CM (about two or three minutes). Turn off the heating

switch, put the frame down, and turn on the vacuum motor at the same time. After

the package is formed, it can be removed.